PCL PAGE MAXIMUM PRINTABLE AREA LEGEND: Ec = [Ctrl] [P] [Esc] is DOS EDIT The maximum printable area can be used by adjusting top and bottom margins so that the distance between the physical page and the first line of text is 1/6 inch based on six lines per inch. The left and right margins have a default 1/4 inch and can only be adjusted using long edge offset registration. EXAMPLE OF MAXIMUM TOP AND BOTTOM MARGINS EcE Reset Ec&l0O Portrait Orientation Command Ec&l1E Top Margin of 1 line Ec&l6D Line spacing, 6 lines per inch Ec&l64F Text Length 64 = number of lines before page ejects NOTE: Avoid setting the top margin or text length to values outside of the printable area as this may cause data loss. If line spacing is adjusted, text length will need to be adjusted accordingly. PERFORATION SKIP The perforation skip command [Ec&l0L] can also be used to disable any top and bottom margins and obtain the maximum PCL page. However, this is not the recommended method as data loss will occur unless a form feed is sent at the end of each page and a cursor position is used for the line at the beginning of the next page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.
Comments:
file: /Techref/language/pcl/lj1559.htm, 2KB, , updated: 2008/3/18 21:49, local time: 2024/12/23 18:21,
18.191.118.36:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://massmind.ecomorder.com/Techref/language/pcl/lj1559.htm"> language pcl lj1559</A> |
Did you find what you needed? |
Welcome to ecomorder.com! |
Ashley Roll has put together a really nice little unit here. Leave off the MAX232 and keep these handy for the few times you need true RS232! |
.