please dont rip this site

  Producers of the 8031 mcu.

ATMEL Flash, E2, low cost and custom devices. Up to 128K+4 K flash. with. "On board" programmable devices.
DALLAS Enhanced speed, NV-RAM, NV-Clock, Dual Serial ports. (Nice ones!)
INTEL 8031 and up, they invented it and still holds the lead in raw speed with the 16 bit MCS251.
OKI Masked variants, 85C154 with piggyback EPROM.
PHILIPS From 83C750 up to the XA 16 bit devices. 
Many special devices with I2C-Bus and big ones with extra I/O and A/D, D/A, PWM etc.
SIEMENS A/D, D/A extra I/O:s and more.
SMC
SMC COM20051 with high speed ARCNET support.
TEMIC CAN/VAN Interface, Low voltage versions, ROM-Security functions.
ISSI Fast 80C31/51 up to 40 MHz. 
TDK Special  modem versions up to 44 MHz, Hardware CRC calculation, Bankswitching support and some other features. 
Also have virtual 16C550 UART interface.
LG (Formerly GoldStar) "GMS90" series mcu, 80C51 compatible and OTP versions of  Atmel 89Cx051.
WINBOND FLASH up to 32K. AD / DA / PWM / I2C devices and extra I/O.
Daewoo Possibly makes MASK-ROM 8051:s. Have not found any pages on these chips.
 Have I missed any source? Please mail me!

file: /Techref/8031/mfgrs.htm, 4KB, , updated: 2001/4/16 13:41, local time: 2024/12/30 09:30, owner: -fmkit.com-2A2,
TOP NEW HELP FIND: 
3.146.255.161:LOG IN
 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://massmind.ecomorder.com/techref/8031/mfgrs.htm"> 8031 Manufacturers</A>
After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?
 

Welcome to ecomorder.com!

 

Welcome to massmind.ecomorder.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .