please dont rip this site

How the ENC2 Encoder works

Technical summary: The ENC2 encoder senses the position of a two pole radially (or diameterically) magnetized disk over a full revolution using a hall effect sensor array. The sensor signal changes are converted to a digital quadrature signal for standard A/B/I signal productoin, and the position information stored as absolute position data on some registers, which are readable through a 3 wire synchronous serial interface.

Detail: Most disk magnets have north and south poles that go out from the flat sides of the disk. One side will be north, the other south. Like this:

But the special magnets (supplied with the encoder) have a north pole that goes out through a point on the curved side of the disk. And the south pole is 180' out on the opposite edge of the curve.

So when the shaft turns the disk, the magnetic field is rotating... not coming and going, but spinning at the same distance.

The chip in the encoder has hall effect magnetic field sensors in it. They have an axis of sensitivity where they pick up the magnet stronger if they are aligned with the magnets field. And there are many of them... 4000 in the ENC2b. Each arranged around a circle in the chip. So one of them is best aligned with the field of the disk magnet. And that one is the one that the chip reports as the current position.

Finally, a circuit in the chip keeps track of which one was aligned and which one is now aligned and puts out the quadrature pulses as that change is detected. Speeds up to 75K RPM on the ENC2a (28K RPM on the ENC2b) are supported.


file: /Techref/io/sensor/pos/enc/enc2howitworks.htm, 1KB, , updated: 2017/10/12 10:13, local time: 2024/11/10 10:48,
TOP NEW HELP FIND: 
3.239.87.20:LOG IN
©2024 PLEASE DON'T RIP! THIS SITE CLOSES OCT 28, 2024 SO LONG AND THANKS FOR ALL THE FISH!

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://massmind.ecomorder.com/techref/io/sensor/pos/enc/enc2howitworks.htm"> How the ENC2 Encoder works</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

 

Welcome to ecomorder.com!

 

Welcome to massmind.ecomorder.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .