PIC Microcontroller Serial Input / Output Methods

• RS232
• RS-485 (RS485)
• I2C
• SPI

NEW! RCL-1 RS232 Level Converter in a DB9 backshell

See:

• http://www.hamradio-online.com/1999/feb/mdecoder.html PIC16F84 Morse Code Reader.
• /techref/piclist/basiccomm/index.htm Basic Comm+

Questions:

• SPAMdimithri at -Remove-gmail.com asks:

  Hello, I am looking to connect a MAX522 DAC through the PIC18F452's SPI interface and a PCF8575 I/O expander through the I2C interface. However both the SPI and I2C modules connect to the same pins of PORTC. Anybody knw away around this? Appreciate it if you cld help...
  Regards,
  Dimithri

• hi there!
  im using PIC16F877 as microcontroller to interface with the pc side via VB program, nevertheless the BasicComm i found it here is quite useful. I would like to know the way on how to send and receive frm the PIC16F877 so that it'll be a close loop control within the hardware and the pc. thank you +
• SPAMbrentano at -Remove-ruhle.com asks:

  I have an application that calls for a 19bit synchronous serial interface: clock supplied externally @ 1.2MHz. I am trying to use the Advanced USART in the 18F1320. I am trying to write out three consecutive 8 bit words, I use a timer to timeout during the middle of the third word to exit (since I only have 19 clocks not 24). The interface works for a short while but then gets stuck waiting to transmit the second byte. Does anyone have any suggestions? Thanks.

  +

Archive:

• List post "Morse speed" Morse code generation with a PIC. +

  .